1. To establish a straight layout line, snap a chalk line parallel to the longest wall, about 30" from the wall. Kneel in this space to begin flooring installation.

2. Apply flooring adhesive to the subfloor on the other side of the layout line with a notched trowel, according to the manufacturer's directions. Take care not to obscure the layout line with adhesive.

3. Apply wood glue to the grooved end of each piece as you install it, to help joints stay tight. Do not apply glue to long sides of boards.

4. Install the first row of flooring with the edge of the tongues directly over chalk line. Make sure end joints are tight, then wipe up any excess glue immediately. At walls, leave a 1/2" space to allow for expansion of the wood. This gap will be covered by the baseboard and base shoe.

5. For succeeding rows, insert the tongue into the groove of the preceding row, and pivot the flooring down into the adhesive. Gently slide the tongue-and-groove ends together. TIP: At walls, you can use a hammer and a hardwood flooring tool bar to draw together the joints on the last strip.

6. After you've installed three or four rows, use a mallet and a scrap of flooring to gently tap boards together, closing up the seams. All joints should fit tightly.

7. Use a cardboard template to fit boards in irregular areas. Cut cardboard to match the space, and allow for a 1/2" expansion gap next to the wall. Trace the template outline on a board, then cut it to fit, using a jig saw. Finish layering strips over the entire floor.

8. Bond the flooring by rolling with a heavy flooring roller. Roll the flooring within 3 hours of the adhesive application. (Rollers can be borrowed or rented from flooring distributors.)