Bed + Bath

DIY Bathroom Towel Holder

Print Page
Towel Tower Project
BDSquareLogo

BLACK+DECKER B+D Contributor 193 Projects

If there’s one place in the house that collects everybody’s stuff, it’s the bathroom. Towels, clothes, cleaning supplies, even laundry. But some fancy design work using a refrigerator wall cabinet and some cool carpentry create a niche spot that can provide a central location for all kinds of different items. Suitable even for small bathrooms, this towel tower also adds texture and color to the space. Another added benefit to this project is the seating provided by the seatboard top on the cabinet. The beadboard backing for this project is made with painted 3⁄8"-thick tongue-and-groove pine, sometimes called carsiding. more advanced carpenters may prefer to make their own custom beadboard from hardwood and give it a custom wood finish. 

The base for this project is an over-the-fridge-size wall cabinet (sometimes called a bridge cabinet). At 15" high, it is within the range of comfortable seating heights. But if you prefer a slightly higher seat (and many people do), build a 2 × 4 curb for the  cabinet to rest on. To conceal the seam where the towel tower meets the floor, we trimmed around the base with base shoe trim, mitering the corners. We used the same trim stock to conceal the gap where the seatboard meets the tongue-and-groove paneling. here, however, we added small miter returns to the ends of the base shoe.

Diagram and Cutting List

How to Build a Bathroom Towel Holder

  1. HI052313C

    Rout a profile, such as an ogee or roundover, into the sides and front of the seatboard. Use a router table if you have one, otherwise hand-machine it with a piloted profiling bit.

  2. HI052313D

    Flip the cabinet upside-down so you can more easily attach the seatboard with screws.

  3. HI052313E

    Drive screws through the back of the cabinet at the marked wall stud locations.

  4. HI052313F

    Lay out the tongue-and-groove carsiding boards in a row, with the tongues fitted into grooves. Measure out in one direction (half the width of base cabinet) from a midpoint line in the center board.

  5. HI052313G

    Clamp a straightedge over a tongue-and-groove board, placing a piece of scrap plywood underneath as a backer. Ripcut the board to the correct thickness for the filler piece.

  6. HI052313H

    Press the trimmed filler board to the wall, seating it in construction adhesive, at the left edge of the panel area.

  7. HI052313I

    Drive a pneumatic brad through the tongue of one of the far-right boards, and into a marked wall stud.

  8. HI052313J

    Install quarter-round or base shoe molding at the top edge of the seatboard where it meets the carsiding. Tie the molding back to the wall with mitered returns.

  9. HI052313K

    Attach crown molding at the top of the project, creating mitered returns at the ends. Mark the ceiling joists with tape.